Service manual

FIXING UNIT
1-O-8
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
[10] Removing and Reinstalling the Fixing
Lower Roller
a. Procedure
(1) Remove the fixing unit.
(2) Remove two screws to remove the fixing
entrance guide plate (lower)
(3) Remove the fixing separation claw (lower) unit.
(4) Remove the fixing lower roller upward.
(5) Remove two bearings from the fixing lower roller.
(6) Reinstall the above parts following the removal
steps in reverse.
Caution:
The fixing entrance guide plate (lower)
should be pressed against the fixing
upper roller bearing when installing.
[11] Removing and Reinstalling the De-
curler roller
a. Procedure
(1) Remove the fixing unit.
(2) Open the fixing unit (top).
(3) Lift the fixing exit guide plate (upper) and remove
two screws to remove the fixing exit guide plate
(lower).
(4) Remove the screw to detach the jam handling
release knob.
(5) From the front side, remove one E-ring, one gear,
one E-ring, one washer, one screw, and bearing
in this order.
(6) From the rear side, remove one E-ring, one
washer, one screw, and bearing in this order and
then remove the decurler roller from the frame.
Fixing entrance guide plate (lower) unit)
Screw
Screw
Fixing lower roller
Bearing
Bearing