Service manual

FIXING UNIT
1-O-12
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
g) When making the adjustment, make sure that
the thermostat/U does not ride on the posi-
tioning jig (C).
(3) Apply screw lock agent to the screw securing the
thermostat/U.
(4) Reverse the removal procedure to install other
parts.
[14] Removing and Reinstalling the Ther-
mostat/L (TS2)
Caution:
This is an important safety part. Be sure to
observe the following cautions and steps
when removing or reinstalling.
Caution1:
After reinstalling the thermostat/L,
make sure that its wires do not touch
the fixing lower roller.
Caution2:
When reinstalling the thermostat/L,
adjust its position using the position-
ing jig (4024-2992-01) and secure it
with screws. Be sure to apply screw
lock agent to the screws. This adjust-
ment should be made in a pressured
state.
a. Removal procedure
(1) Remove the fixing lower roller.
(2) Close the fixing cover (top).
(3) Remove the two Faston terminals of the thermo-
stat/L through the fixing entrance side.
(4) Open the fixing cover (top).
(5) Remove two screws to remove the thermostat/L.
(A)
(B)
(C)
Faston
Screws
Thermostat/L