Service manual

RADF

1-P-3

3 DIS./ASSEMBLY1 DIS./ASSEMBLY

(5) Install two RADF positioning jigs in the mounting

holes of the original stopper plates (left).

(6) Close the RADF to mate the reference holes and

RADF positioning jigs.

(7) Install three screws to secure each of the two fix-

ing plates with three screws following the

removal procedure in reverse.

(8) Open the RADF and tighten all of the six screws

to secure the two fixing plates.

(9) Remove the RADF positioning jigs and install the

original stopper plate (left) with two screws.

(10) Remove two screws and uninstall the top cover

(left).

(11) Close the RADF and check whether both stopper

pieces on the RADF-side touch the slit glass.

(12) If both stopper pieces do not touch the slit glass

at the same time, make adjustments using

adjusting screws A and B alternately.

(13) Perform steps 11 and 12 repeatedly until the two

stopper pieces touch the slit glass at the same

time.

(14) For further installation, follow the removal proce-

dure in reverse.

RADF positioning jigs

Reference hole (round)

Reference hole

(oval)

Screws (2)

Stopper piece

Top cover (left)

Adjusting screws B Adjusting screws A