Service manual

LCT
1-Q-4
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
(3) Remove two screws to detach the double feed
prevention roller unit.
Caution:
When reinstalling the double feed pre-
vention roller unit, tighten the screws
on the rear side first.
(4) Remove two stop rings, fit the shaft into the D-cut
in the fitting, and remove the double feed preven-
tion roller together with the shaft.
(5) Remove the double feed prevention roller rubber
from the double feed prevention roller.
(6) Reinstall the double feed prevention roller in the
reverse order of the removal procedure.
Caution1:
Make sure the double feed preven-
tion roller rubber is oriented properly
when reinstalling it.
Caution2:
Check whether scratch or the like is
visible on the pet cover for the drive
gear.
Caution3:
Check whether grease or the like is
present on double feed prevention
roller.
Double feed prevention roller unit
Screws
Double feed prevention roller
Stop rings
D-cut
2
1
3
Paint mark
1. Double feed prevention roller
2. Shaft
3. Double feed prevention roller rubber