Service manual

FN
1-R-10
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
(3) Remove two screws. Detach the wire bracket on
the rear from the up/down stay.
(4) Loosen the two screws on the belt tensioner.
(5) Remove the E-ring and the up/down pulley/L.
Then remove the up/down wire.
CAUTION:
When you remove the up/down pul-
ley, the pin falls. Be careful not to lose
the pin.
(6) Temporarily attach the wire bracket to the up/
down stay with two screws.
CAUTION:
The wire bracket must be installed
with the longer portion of the wire
facing upward.
2
1
3
4
1. Screw
2. Up/down stay
3. Wire bracket
4. Up/down wire
Screw
Belt tensioner
Pins
E-ring
Gear
Up/down wire
Up/down pulley/L.
2
1
3
4
1. Up/down stay
2. Screw
3. Wire bracket
4. Up/down wire
Longer portion of wire
Shorter portion of wire