Service manual

FN
1-R-12
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
(11) Loosen the two screws securing the front wire
bracket. Adjust the height of the front wire
bracket to level the up/down stay. Tighten the four
mounting screws on the wire brackets (front and
rear).
CAUTION:
Make sure that the up/down stay is
level. If the stay is mounted aslant, an
unnecessary load is put on the tray
up/down motor (M703) or the gear,
which may result in damage to these
components.
(12) Reinstall the above parts following the removal
steps in reverse.
2
2
1
3
4
1. Mounting screws
2. Wire brackets
3. Up/down stay
4. Screws