Service manual

FN
1-R-16
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
[2] Removing and Reinstalling the
Clincher
Caution
:
Make sure that the power cord of the main
body is unplugged from the power outlet.
Caution
:
Be sure to perform the adjustment work
described in the "FNS Stapler Upper/
Lower Positions Adjustment" of the man-
ual, "Adjustment," after you have attached
the clincher.
a. Procedure
(1) Open the front door.
(2) Pull the stacker unit out and remove the stapler
unit cover.
(3) Remove a mounting screw holding the ground
cable. Remove the ground cable and the clamp.
(4) Remove four screws securing the clincher.
Detach the clincher/F and the connector.
(5) Remove four mounting screws holding the
clincher/R.
(6) Remove two screws. Detach the ball bearing
bracket, and then remove the clincher/R by rotat-
ing it to the appropriate position. Remove the
connector.
CAUTION:
Do not lose the bearing spring and
the ball.
(7) Reinstall the above parts following the removal
steps in reverse.
2
2
1
5
3
4
1. Clincher/F
2. Screw
3. Connector
4. Ground
5. Clamp
Screw
Screw
Ground
Clincher/R
2
1
5
3
4
1. Clincher/R
2. Connector
3. Screw
4. Ball bearing bracket
5. Bearing spring