Service manual

PI
1-S-1
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
EXTERNAL SECTION
[1] Removing / Re-installing the External
covers
Caution
:
Make sure that the power cord of the main
body is unplugged from the power outlet.
a. Procedure
(1) Remove cap on the top cover.
(2) Remove four screws to detach the top cover.
(3) Remove one screw to detach the connector
cover.
(4) Remove three screws to detach the lower cover.
(5) Remove two screws, disconnect the relay con-
nector (CN232), and detach the operation panel
cover.
(6) Reinstall the above parts following the removal
steps in reverse.
Screws
Top cover
Cap
Screws
Lower cover
Connector cover
Screw
operation panel cover
Screw
Relay connector (CN232)