Service manual

ADJUSTMENT
2-41
2 ADJUSTMENT
69 FNS up/down motor 1 is counted each time the paper from FNS main
tray is ejected. 1 is counted each time a copy is
ejected in stapling mode.
70 FNS stapler/front 99999999 1 is counted each time a copy is ejected in sta-
pling front 1-point stapling, stapling 2-point sta-
pling, or middle binding mode.
71 FNS stapler/rear
72 FNS shift motor 1 is counted each time even-numbered paper is
ejected.
73 FNS exit opening open/close
motor
1 is counted each time large size stapling (A4R/
8.5x11R or larger) job starts. 1 is counted each
time paper is ejected from each section. 1 is
counted each time stitch and fold or folding job
starts.
74 FNS folding knife motor 1 is counted each time one set of papers in sta-
pling/folding, folding, or three-holding mode is
ejected.
75 FNS By-pass SD 1 is counted each time one set of papers in DM
folding mode is ejected.
76 FNS DM gate SD Counted each time one paper is ejected in three-
holding mode
77 PI sheet feed clutch/U Counted each time are paper is fed into PI/U
78 PI feed roller unit/A
79 PI feed roller unit/B
80
PI reverse robber unit
81
PI torque limiter
82
PI sheet feed clutch/L Counted each time one paper is fed into PI/L
83
PI feed roller unit/A
84
PI feed roller unit/B
85
PI reverse robber unit
86
PI torque limiter
87
Trimmer knife 1 is counted each time knife movement is made
88
Punched holes
(2 holes)
Number of ejected papers with the punch mode
selected
89
Punched holes
(3 holes)
90
Punched holes
(4 holes)
91
Punched holes
(2/3 holes)
Not used
92
ADF feed roller Number of originals passes in all modes
93
ADF Separation roller
94
ADF double-feed prevention
robber
95
ADF double-feed prevention
roller
96
ADF paper exit solenoid 1 is counted each time one original passes in the
double side or the mixed mode
NO Part name
Maximum
count
Counting condition