Service manual

ADJUSTMENT
2-82
2 ADJUSTMENT
5. Three-folding adjustment
Adjusting the folding positions during the three-
folded copy.
[20] List Output Mode
Outputting various data.
1. Select " List output mode" in the Adjustment
mode menu Screen to display the List output
mode menu Screen.
2. List output mode menu consists of the following:
Machine management list 1
Adjustment data list
Black ratio data list
Machine management list 2
Parameter list
Memory dump list
Font pattern
3. Press the number key corresponding to the item
to output.
The output setting screen for the selected item
appears.
4. After output completes, return to the List output
mode menu Screen.
5. Press the key in the List output mode
menu Screen to return to Adjustment mode
menu Screen.
Note:
List output screen is not displayed for
Machine management list 2 and subse-
quent items unless address 30-1 is set to
1 with Software DIPSW setting in 25
mode.
Step Operation
1
Enter the 36 mode.
2
[Adjustment mode menu Screen]
Press " Finisher adjustment".
3
[Finisher Adjustment mode Menu
Screen]
Press " Three-holded positions
adjustment".
4
[Three-Folding adjustment Screen]
Press the key.
5
Load papers in the tray, place the original on
RADF, and then press the START button.
6
Check the three-holded positions of
paper.
7
If the folded positions are not within the
specification, press the C button while
pressing the Utility key.
8
[Three-Folding adjustment Screen]
Press the or key to
select the item to be adjusted.
9
Enter a value with numeric keys and
press the key.
Setting range: -128 to +127
1 step=0.1mm
10
Repeat steps 4-9 until the folded posi-
tions are within the specification.
11
Press the key to return to
the Finisher adjustment mode menu
Screen.
6
7
COPY SCREEN
a
b
c
Folded
positions
Reference value
Specifi-
cation
A4R 8.5x11R
a 93mm 86.4mm
±
2mm
b 102mm 97mm
±
2mm
c 102mm 97mm
±
2mm
NEXT BACK
SET
RETURN
7
1
2
3
4
5
6
7
RETURN
4
1