Service manual

ADJUSTMENT
2-99
2 ADJUSTMENT
4. Setting the LCT Rear Guide (C-404 only)
a. Adjustment method
Reference:
LCT tray size setting can be per-
formed in the key operation mode
by setting DIPSW21-1 to 1 in the 25
mode.
Standard value of mis-centring: within 3mm
Within 3mm
Centre of image
Centre of paper
Step Operation
1
Open the top cover.
2
Press SW100 (LT tray down switch) to
lower the up/down plate to the bottom.
3
Loosen two screws at the top of the rear
guide and one screw at the bottom.
4
Set paper on the up/down plate, align the
trailing edge of paper with the lower end
of the rear guide, then fasten the lower
screw.
5
Fasten the two upper screws temporarily
and move the up/down plate to the high-
est position.
6
Set paper on the up/down plate, align the
trailing edge of paper with the upper end
of the rear guide, then tighten the two
upper screws finally.
Rear guide
Rear guide
Screws
Screw