Service manual

ADJUSTMENT
2-109
2 ADJUSTMENT
[10] RADF Skew adjustment
1. Tool
• Hexagonal wrench
• Open-end wrench or flat-nose pliers
2. Adjustment method
Step Operation
1
Set A3 paper into the upper tray.
2
Set the adjustment chart on the RADF,
make a copy, and check the skew.
Standard value: within
±
0.3%
Perform the following adjustment if the
skew is beyond the standard value.
Nut
Skew adjustment
screw
Skew pattern A
Skew pattern B
Skew pattern A Skew pattern B
Feed
direction
3
Remove two screws for each of the two
stoppers.
4
Loosen the three screws illustrated.
Screws Screws
Stopper 2
Stopper 1
Fixing plate Fixing plate
Screw
Screws