Service manual

ADJUSTMENT
2-110
2 ADJUSTMENT
[11] RADF paper skew adjustment
1. Face side of original paper skew adjustment
Note:
Perform this adjustment after completing
the RADF skew adjustment described in
the previous page.
5
Open the RADF and loosen the six
screws illustrated.
6
Close the RADF and loosen the nut of
skew adjustment screw.
7
Turn the skew adjustment screw to
adjust the skew.
For the skew pattern A:
Turn the skew adjustment screw coun-
terclockwise and move the RADF until
it reaches the tip of the screw.
For the skew pattern B:
Turn the skew adjustment screw clock-
wise.
8
Make a copy to check the skew.
9
Fasten the skew adjustment screw with
its nut.
10
Fasten the RADF securing screws (9,
with 6 in front and 3 in rear).
11
Make adjustment by repeating steps 3 to
9 until the skew becomes within the stan-
dard value.
12
Use two screws to install each of the two
stoppers.
ScrewsScrews
Step Operation
1
Make a copy in the single sided to single
sided copy mode, then check the skew of
the original. (Either pattern A or B)
2
Open the Jam access cover.
3
Loosen the retaining screw to release
the registration roller bracket.
Registration
roller bracket
Registration roller
Screw
Jam access cover
Paper skew pattern A Paper skew pattern B
Image
Copy paper
Copypaper
feed direction