Service manual

ADJUSTMENT
2-111
2 ADJUSTMENT
2. Back side of original paper skew adjustment
4
Move the registration roller bracket one
calibration in the direction below accord-
ing to the paper skew pattern.
For skew in pattern A:
Move the registration roller bracket
downwards (direction down with orig-
inal feed flow).
For skew in pattern B:
Move the registration roller bracket
upwards (direction up towards original
feed flow).
5
Repeat steps 2 to 4 unitl the original
skew is within specified range (0.5% or
less).
Specified range: Paper skew
±
0.5% or
less (Paper skew in the paper feed direc-
tion)
Step Operation
1
Make a copy in the double sided - single
sided copy mode, then check the skew of
the original. (Either pattern A or B)
2
Open the Jam access cover.
3
Loosen the set screw and release the R
range adjustment plate.
4
Move the R range adjustment plate one
calibration in the direction below accord-
ing to the paper skew pattern.
For skew in pattern A:
Move the R range adjustment plate to
left side.
For skew in pattern B:
Move the R range adjustment plate to
right side.
5
Repeat steps 2 to 4 until the original
skew is within specified range (0.5% or
less).
Specified range: Paper skew
±
0.5% or
less (Paper skew in the paper feed direc-
tion)
Jam access cover
R range adjustment plate
Left side
Right side
Screw
Paper skew pattern A Paper skew pattern B
Image
Copy paper
Copypaper
feed direction