Service manual

ADJUSTMENT
2-117
2 ADJUSTMENT
[16] FNS Adjusting the mount location of
the paper exit arm
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
3
Place the solenoid to its original position,
and tighten the screw securing the sole-
noid bracket at the position where the
paper exit guide makes contact with the
cushioning rubber of the paper exit guide
stay.
Caution:
Make sure that the difference
in height between the paper
exit guide and the paper exit
guide stay is 1mm and
greater.
4
Reassemble in the opposite sequence
to the removal.
Step Operation
1mm
Solenoid bracket
Screws
Stopping
rubber
Paper exit
guide stay
Paper exit guide
Paper exit guide
Step Operation
1
Open the front door and pull out the
stacker unit.
2
When aligning the actuator edge of the
belt detection gear with the notch of
panel /rear, check whether the top sur-
face of paper exit belt arm is positioned
in the middle of the two marks.
3
Perform the adjustment if it is out of spec.
Notch of panel /rear
Belt detection gear
Actuator edge
Marks
Top surface of paper exit belt arm