Service manual

ADJUSTMENT
2-119
2 ADJUSTMENT
b. Adjustment
[18] FNS Adjusting the mount location of
the alignment plates / L (FN-6 only)
1. Tool
• Screwdriver (Phillips)
•Scale
2. Adjustment method
a. Preparation
4
Check whether the distances A and B for
the alignment plate /U are within speci-
fication.
Spec values:A=337±0.5mm(within)
B=49
±
0.5
5
If they are out of spec, perform the fol-
lowing adjustment:
Step Operation
1
Loosen the two screws and perform the
adjustment so that the mount location of
the alignment plate /U are within speci-
fication.
Step Operation
A=337 0.5m
m
B=49 0.5m
m
Rear
panel
Alignment plate /U
Alignment plate /U
Screw
Screws
Step Operation
1
Make sure that "Adjusting the mount
location of the alignment plates / U" is
finished.
2
Power on the main body, drive the
motor(s) using the following codes in the
47 mode, and then power the machine
off.
• Code 75-8: Alignment /U (M705) HP
search
• Code 75-21: Alignment /L (M716) HP
search
• Code 75-40: Stopper (M718) position-
ing shift (larger than A4R)
3
Open the front door and pull out the
stacker unit.
4
Take off the stapler unit cover.
5
Check whether the actuators for the
alignment HP/ U (PS705) and the align-
ment HP/ L (PS724) are aligned with the
home position.
Alignment plate /L
Alignment HP PS/L
(PS724)