Service manual

ADJUSTMENT
2-130
2 ADJUSTMENT
2
When adjusting for the lower tray,
remove two screws and slide rightward
to remove the side guide plate (rear).
3
Loosen two adjustment screws securing
the side guide plate (rear), and slide it by
the twice the difference.
(ie: If there is 1.5mm difference in direc-
tion of rear side, slide by 3mm to rear
side.)
4
Fasten the two adjustment screws
securely to fix the side guide plate (rear).
5
In case of the lower tray, install the side
guide plate (rear).
6
Set a sheet on the tray and fit the side
guide plate (rear) to the sheet to check
that the side guide plate (rear) is parallel
to the sheet.
7
Feed the three sheets from PI with the
punch mode.
8
Check the position of each punch hole.
9
Repeat step 2 to 8 until the difference of
the holes is improved.
10
Install the adjustment cover to the side
guide plate (rear).
Step Operation
Side guide plate
(rear)
Screws
Adjustment
screws
Side guide plate (rear)
11
Set A4R size paper to the tray and per-
form the cover sheet tray size adjust-
ment in 36 mode.
Step Operation