Service manual

DRUM UNIT
1-E-5
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
(7) Remove two screws and detach the separation
claw SD (SD1).
(8) Reinstall the above parts following the removal
steps in reverse.
Caution:
When installing the separation claw
unit, match the pin and guide hole
shown in the figure.
[Reference]
When removing the separation claw solenoid
(Normally, it should not be removed except when
replacing the solenoid).
(1) Install the separation claw unit to the drum
unit.
(2) Tighten the solenoid screw when the claw
closest to the drum touches the drum.
(3) Set the drum unit to the main body and
check that the tips of the separation claws
are off the drum. (Standard clearance: More
than 0 mm up to 1mm.)
Screws
Separation claw SD (SD1)
2
1
3
4
1. Drum unit
2. Pin
3. Separation guide plate assembly
4. Guide hole
2
1
3
4
1. Separation claw SD (SD1)
2. Screws
3. Separation claw
4. Drum unit
(Bottom surface of the drum unit)