Service manual

CORONA UNIT
1-F-6
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
(6) Release and remove three wires from each
cleaning block.
Caution:
Be careful not to drop and lose the
support rubber when removing the
wire.
(7) Turn the transfer/separation corona unit upside
down, remove the stop rings, and remove the
transfer wire cleaning block and separation wire
cleaning block from the front side.
(8) Reinstall the above parts following the removal
steps in reverse.
Caution:
When installing the transfer/separa-
tion wires, check that the coupling of
the cleaning pad drive gear is
engaged correctly.
2
1
3
4
3
1
1. Transfer wire
2. Spring
3. Separation wire
4. Support rubber
2
1
3
4
1. Stop rings
2. Coupling
3. Separation wire cleaning block
4. Transfer wire cleaning block