Service manual

CORONA UNIT
1-F-7
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
[11] Removing and Reinstalling the TSL
Unit
Caution:
Be sure the power cord has been
unplugged from the wall outlet.
a. Procedure
(1) Draw the ADU frame from the main body. (See
"ADU UNIT.")
(2) Remove the transfer/separation corona unit.
(3) Remove the relay connector (CN463).
Caution:
A relay connector consists of two male
sides and one female side. Be sure to
remove only the male side (shown
below) of the CN463 connector.
(4) Remove the three screws and remove the TSL
unit.
(5) Reinstall the above parts following the removal
steps in reverse.
Screws
TSL unit
Relay connector (CN463)