Service manual

BY-PASS FEED TRAY
1-L-2
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
[3] Replacing the Double Feed Preven-
tion Roller Rubber
a. Procedure
(1) Remove the by-pass feed tray and place the tray
upside down.
(2) Remove two screws to remove the bottom plate
assembly.
(3) Remove the spring.
(4) Remove the double feed prevention roller
assembly from the by-pass feed tray unit.
(5) Remove the stop ring to pull out the shaft and
remove the double feed prevention roller rubber
from the double feed prevention roller.
(6) Reinstall the above parts following the removal
steps in reverse.
Caution1:
Check that the orientation of the dou-
ble feed prevention roller is correct
when installing.
Caution2:
Check that no grease or the like
remains on the double feed preven-
tion roller.
Caution3:
There are three spring holes. Insert
the spring in the middle hole.
2
1
3
4
1. Screws (2)
2. Bottom plate assembly
3. Spring hole
4. Spring
2
1
5
3
4
1. Double feed prevention roller
2. Double feed prevention roller rubber
3. Shaft
4. Double feed prevention roller assembly
5. Stop ring
Paint mark