Service manual

ADU UNIT
1-N-13
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
(7) Remove two screws to release the high voltage
supply unit (1).
(8) Disconnect the two connectors (CN460, 461).
Caution:
Each relay connector consists of two
male sides and one female side. Be
sure to remove only the male side
(shown below) of the connector.
(9) Remove two screws to remove the conveyance
unit.
(10) Disconnect the three connectors (CN421, 426,
427)
Caution:
Each relay connector consists of two
male sides and one female side. Be
sure to remove only the male side
(shown below) of the connector.
(11) Remove two screws to remove the harness
guide plate (front).
(12) Remove four screws to detach the registration
drive motor assembly.
2
1
5
3
4
2
2
2
1
5
3
4
3
1. Relay connector (CN427)
2. Relay connector (CN421)
3. Screws
4. Harness guide (front)
5. Relay connector (CN426)
Screw
Screws (3)
registration drive motor assembly
1. High voltage supply unit (1)
2. Screws
3. Relay connector (CN460)
4. Relay connector (CN461)
5. Conveyance unit