Service manual

ADU UNIT
1-N-14
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
(13) Remove the stop rings to remove the ADU decel-
eration MC (MC2) and ADU conveyance MC
(MC13).
(14) Remove the E-ring at the rear, two belt holding
collars, ADU conveyance belt (1), and two ADU
conveyance pulleys.
(15) Remove the pin from each roller shaft.
(16) Remove the E-ring and bearing on the inside of
the ADU conveyance pulley.
(17) Remove the E-ring on the ADU conveyance
roller(3) shaft.
(18) Remove the front E-ring and bearing, and
remove the ADU conveyance roller (3) and ADU
conveyance roller (4) by sliding them back and
forth.
(19) Reinstall the above parts following the removal
steps in reverse.
2
1
3
3
2
2
1
1
6
7
5
3
3
3
33
8
4
4
1. Bearing
2. ADU conveyance belt (1)
3. E-ring
4. Pin
5. Belt holding collars
6. ADU conveyance pulley
7. ADU conveyance roller(3)
8. ADU conveyance roller (4)
1. ADU conveyance MC (MC13)
2. ADU deceleration MC (MC2)
3. Stop rings