Operator`s manual

Action
Using the Corona Unit Cleaning Levers, clean the Corona Units.
➭
p. 114
Wipe the Original Glass clean with a soft dry cloth.
➭
p. 112
Wipe the Original Pad or Document Transport Belt clean with a soft cloth dampened with
neutral detergent.
➭
pp. 112, 115
Place a blank sheet of paper over the original.
➭
p. 28
The information on the back side of a two-sided, thin original may be slightly reproduced
on the copy. Set the copier into the Manual Exposure Mode and, using the Exposure
Control Key (Lighter), make the exposure level lighter.
➭
p. 41
Wipe the Original Pad or Document Transport Belt clean with a soft cloth dampened with
neutral detergent.
➭
pp. 112, 115
Load the same size copy paper as the original into the Drawer.
➭
p. 72
Load the same size copy paper onto the Manual Bypass Table or the Multi Bypass Table.
➭
p. 49
Reload the paper in the same direction as the original.
➭
p. 28
Select the zoom ratio according to the copy paper size.
➭
p. 35
Or, use the Auto Size Mode to reduce the copy to the appropriate size.
➭
p. 37
Place the original correctly on the Original Glass against the Original Width Scale.
➭
p. 28
Or, load it onto the AF-3 correctly along the Document Guide Plates.
➭
p. 31
Raise the AF-3, and place the originals on the Original Glass, one at a time, instead of
using the AF-3.
➭
p. 32
Wipe the Original Glass clean with a soft dry cloth.
➭
p. 112
If these procedures do not correct the problem, contact your Technical
Representative
1. When this Type of Copy is Produced
Chapter 6
Troubleshooting
99