Operator`s manual

Minimizing the Warm-up Time
If the copier is shut down when it is not in use, it takes the copier a max. of 1
minute to complete the warm-up cycle. Instead of turning the copier OFF, it’s a
good idea to use the Energy Saver Mode. The Mode will minimize the time it
takes the copier to complete the warm-up cycle to about 30 seconds.
Entering the Energy Saver Mode
Energy Saver
Panel Reset
1142O093CA
1142O093CA
•
To set the copier into the Energy
Saver Mode, press the Energy Saver
Key on the control panel.
◆
Then, all control panel Indicators
go out, except that the Start Key
and the Energy Saver Key which
remain lit green.
Energy Saver
Panel Reset
1
4
7
3
6
9
C
2
5
8
0
Start Stop
1142O136DC
A
100%
Meter Count
Toner
Drum Dehumidify
Paper
%
50%~200%
Auto
Lighter Darker
Auto Size Sort Book
141% A4 A3
115% B4 A3
100% Full Size
81% B4 A4
70% A3 A4
1142O136DC
1139O2360A
Leaving the Energy Saver Mode
•
To allow the copier to leave the
Energy Saver Mode, press any Key
on the control panel, for instance, the
Start Key.
◆
This cancels the Energy Saver
Mode, and the copier will be ready
to make copies in about 30 seconds.
Chapter 2
First Things to Know about your Copier
4. Turning ON and OFF, and Resetting the Copier
21