Operator`s manual

Manual Bypass Copying
Use the Manual Bypass to make copies on paper not loaded in the Drawer, or to
copy onto transparencies, translucent paper, or any other special paper.
If the copier is equipped with a Multi Bypass Table (option), you can load more
than one sheet of paper for a continuous run.
◆
Types of Paper
•
Plain paper (weighing 60 g to 90 g/m
2
)
•
Heavyweight paper (weighing 90 g to 157 g/m
2
)
•
Transparencies, translucent paper
◆
Paper Size
•
Width: 100 mm to 297 mm
•
Length: 140 mm to 432 mm
◆
Capacity
•
Plain paper, heavyweight paper, transparencies, translucent paper ... 1 sheet at a time
<Multi Bypass Table>
•
Plain paper: Approx. 50 sheets
•
Heavyweight paper, transparencies, translucent paper: Approx. 20 sheets
1139O0150A
Place the original on the Original
Glass and make the control panel
settings.
Insert the copy paper into the
Manual Bypass Table.
◆
This automatically starts the
copy cycle.
Using the Manual Bypass Table
1
2
•
Insert the copy paper one sheet at a time.
•
Do not insert a sheet of paper while the copier is warming up or in a
multi-copy cycle.
•
The Auto Size Mode and Book Copying Mode cannot be selected for manual
bypass copying.
NOTES
Chapter 3
Making Copies
2. Copying Procedure
49