Specifications

Interleaf EP1052 SWITCHES ON PWBs/TECH. REP. SETTINGS
96.11.01
S-15
[Service Mode " Tech. Rep. Choice]
Choice No.
Setting (The default is .)
Highlighted
C-7 <IU 60K Stop>
Select whether or not to inhibit copying when IU Counter has counted 60K.
Default: 0 (inch areas) / 1 (metric areas)
Data
Description Permits copying. Inhibits copying.
10
C-15 <Toner Empty Stop>
Select whether or not to inhibit copying when a toner-empty condition is
detected.
NOTE: If “1” is set, the copier inhibits copying when it detects a T/C of 2% or
lower.
Data
Description Permits copying. Inhibits copying.
0
1
C-20 <Leading Edge Erase>
Varies the width of erase on the leading edge.
NOTE: When the setting is changed, it results in the erase width being changed
by about 3 mm.
Data
Description Smaller width Greater width
1
0
C-21 <Trailing Edge Erase>
Varies the width of erase on the trailing edge.
NOTE: When the setting is changed, it results in the erase width being changed
by about 3 mm.
Data
Description Smaller width Greater width
1
0
C-23 <Loop Length Adjustment>
Adjust the length of the loop to be formed in paper before the Synchronizing
Rollers.
Data Description
Loop length about 4.9 mm
Loop length about 5.6 mm
Loop length about 6.3 mm
Loop length about 7.0 mm
47
48
49
Data Description
Loop length about 7.7 mm
Loop length about 8.4 mm
Loop length about 9.1 mm
51
52
53
50