Specifications

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT
96.11.01
D-6
No. Part Name Removal Procedure
1 Front Door Swing down No.1. Remove one screw that secures the
Belt. Remove two screws that secure the Front Door (only
on one side). Slide the Door to the side from which the
screws have been removed.
2 Control Panel Swing down No.1. Remove No.9. Release and swing up
the Upper Half of the copier. Remove No.21. Remove
two screws that secure the control panel and loosen another
five screws that secure the control panel.
3 Original Scales
4 Original Glass
Remove two screws that secure the Scales.
5 Rear Upper Cover
(Small)
Remove the Original Cover. Release and swing up the
Upper Half of the copier. Remove the Screw Cover and one
mounting screw of No.5.
6 Left Hinge Cover Remove the Original Cover. Remove one screw that
secures the Left Hinge Cover.
7 Rear Upper Cover
8 Right Hinge Cover
Remove the Original Cover. Remove No.6, 8 and 9.
9 Upper Right Cover
Remove one screw that secures No.7.
10 Right Cover Remove No.11. Remove No.9. Remove two screws that
secure No.10.
11 Middle Right Cover Remove four screws that secure No.11.
12 Right Door Open No.12 and remove it by lifting it up.
13 Multi Bypass Table
Mounting Bracket
Remove two screws that secure the Multi Bypass Table
Mounting Bracket.
14 Counter Cover Remove No.14 by snapping if off.
15 1st Drawer Slide out the Drawer and remove one screw that secures the
Stopper at the rear left corner.
16 Rear Cover Swing down No.1. Release and swing up the Upper Half of
the copier. Remove two screws that secure the Rear Cover.
17 Upper Rear Cover Swing down No.1. Release and swing up the Upper Half of
the copier. Remove three screws that secure the Upper
Rear Cover.
18 Original Cover
Remove the Original Cover by pulling it up.