Specifications

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT
96.11.01
D-19
(2) Winding of the Lens Drive Cable
1. Hold the Cable Drive Gear in position with its Bead at the
bottom.
2. Wind the shorter length of the Cable three turns clockwise
around the Cable Drive Gear, working from the back to the
front side. Then tape it.
3. Wind the longer length of the Cable five turns counter-
clockwise around the Cable Drive Gear, working from the
front to back side. Then tape it.
4. Slide the Cable Drive Gear onto its shaft and insert a
wrench into the hole to position the Cable Drive Gear.
5. Pass the longer length of the Cable through the U-shaped
hole in the Light Blocking Plate and wind it around the
Pulley farther away from the Cable Drive Gear.