Specifications

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT
96.11.01
D-49
(4) Adjustment of the ATDC Sensor
z Important
D This adjustment is not necessary when a new Imaging Unit has been installed. (The ATDC Sensor is
automatically adjusted when the starter is charged and the Power Switch turn ON.)
D The adjustment must be made whenever the currently used Imaging Unit has been charged with new
starter.
NOTE
The I/U Counter available from the Consumables counter menu is automatically reset when the ATDC
Sensor gain adjustment has been completed.
The Full Size key can be used to alternately display the data on the Magnification Ratio Indicator, either
the ATDC Sensor output voltage or ATDC Sensor gain.
1. Load the starter.
2. On the control panel, press the Stop Key, Multi-Copy Key
“0,” Stop Key, and Multi-Copy Key “1,” in that order, to set
the copier into a state ready to enter a particular Tech. Rep.
Mode.
3. Press Multi-Copy Keys “1” and “8” to set the copier into the
F8 Test Mode. (At this time, the Multi-Copy Display shows
“F8.”)
4. Press the Start Key to let the copier make the ATDC Sen-
sor adjustment automatically. (It takes about 5 min. for the
copier to complete the adjustment procedure.)
5. After the adjustment has been made, press the Panel Re-
set Key twice (or turn OFF the Power Switch) to return the
copier back into the normal mode.