Specifications

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT

96.11.01

D-53

(8) Adjustment of the Leading Edge Registration

Full Size

z Requirement

D Setting value range: 30 to 70

D Movement equivalent to 1 step of setting value: 0.28 mm

z Important

D After having set the copier into the Adjust Mode, make two single copies and use the second copy for

the check. (The first copy represents the data before adjustment.)

D When full size leading edge registration has been adjusted, it affects leading edge registration in the

enlargement and reduction mode. Be sure, therefore, to check for registration in these modes, too.

D Ready a test chart (A3 or 11” 17”) as shown on the left.

Draw a line across the test chart at a point 20 mm from

the leading edge and use it as the reference line.

Dimension A at the center on the copy should meet the

following requirements.

Mag. Ratio Dimension A (mm)

Full Size (100 %)

Enlargement (200 %)

Reduction (50 %)

20.0 ± 1.5

40.0 ± 3

10.0 ± 1.5

1. Place the test chart face down on the Original Glass and

align its rear left corner with the marker on the Original

Width Scale on the left side of the platen. Then, lower the

Original Cover.

2. Make two single copies in full size mode (100 %) and

check for leading edge registration on the second copy.

(If it meets the requirement, go to “Adjustment of Enlarge-

ment Leading Edge Registration.”)