Specifications

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT
96.11.01
D-55
Enlargement
1. After the leading edge registration in the full size mode has
been adjusted, make two single copies in an enlargement
mode (200 %) and check for leading edge registration on
the second copy.
(If the enlargement leading edge registration meets the re-
quirement, go to “Adjustment of Reduction Leading Edge
Registration.”)
2. If the registration does not meet the requirement, go to the
control panel and press the Stop Key, Multi-Copy Key “0,”
Stop Key, and Multi-Copy Key “1,” in that order, to set the
copier into a state ready to enter a particular Tech. Rep.
Mode.
3. Press the Stop Key and then press the Start Key to set the
copier into the Adjust Mode. (At this time, the Magnification
Ratio Indicator shows “A.”)
4. Press Multi-Copy Key “5” and press the Start Key. (Then,
the Magnification Ratio Indicator shows “A 5” and the Mul-
ti-Copy Display, the current setting value.)
5. Press the Clear Key to clear the current setting value.
6. With the old setting value used as reference, enter the new
setting value using the appropriate Multi-Copy Keys.
NOTE
If dimension A on the copy is smaller than 8.5 mm,
decrease the setting value.
If dimension A on the copy is greater than 11.5 mm,
increase the setting value.
7. Press the Start Key to validate the new setting.
8. Press the Panel Reset Key twice (or turn OFF the Power
Switch) to return the copier back to the normal mode.
9. Make two single copies and check for leading edge regis-
tration on the second copy. (If it does not meet the require-
ment, perform steps 2 through 9 again.)