Specifications

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT
96.11.01
D-56
Reduction
1. After the leading edge registration in an enlargement
mode has been adjusted, make two single copies in a re-
duction mode (50 %) and check for leading edge registra-
tion on the second copy.
2. If the registration does not meet the requirement, go to the
control panel and press the Stop Key, Multi-Copy Key “0”.
Stop Key, and Multi-Copy Key “1”, in that order, to set the
copier into a state ready to enter a particular Tech. Rep.
Mode.
3. Press the Stop Key and then press the Start Key to set the
copier into the Adjust Mode. (At this time, the Magnification
Ration Indicator shows “A.”)
4. Press Multi-Copy Key “5” and press the Start Key. (Then,
the Magnification Ratio Indicator shows “A5” and the Multi-
Copy Display, the current setting value.)
5. Press the Clear Key to clear the current setting value.
6. With the old setting value used as reference, enter the new
setting value using the appropriate Multi-Copy Keys.
NOTE
If dimension A on the copy is smaller than 8.5 mm, de-
crease the setting value.
If dimension A on the copy is greater than 11.5 mm, in-
crease the setting value.
7. Press the Start Key to validate the new setting.
8. Press the Panel Reset Key twice (or turn OFF the Power
Switch) to return the copier back to the normal mode.
9. Make two single copies and check for leading edge regis-
tration on the second copy. (If it does not meet the require-
ment, perform step 2 through 9 again.)