Specifications

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT
96.11.01
D-57
(9) Adjustment of the Image Leading Edge Erase Width
z Requirement
D Setting value range: 42 to 58
D Movement equivalent to 1 step of setting value: 0.75 mm
D Having a greater setting value results in a greater erase width.
D Having a smaller setting value results in a smaller erase width.
z Important
D This adjustment must be made after the leading edge registration adjustment has been completed.
D Ready a test chart (A3 or 11” 17”) as shown on the left.
Paint a 20 mm-long rectangle in black at the center of the
test chart along its leading edge as shown. Adjust so that
the erase width along the leading edge of the painted
area measures 0.5 to 6.5 mm.
1. Place the test chart face down on the Original Glass and
align its rear left corner with the marker on the Original
Width Scale on the left side of the platen.
Then, lower the Original Cover.
2. Make two single copies in full size mode (100 %) and
check for leading edge erase width on the second copy.
3. If the erase width does not meet the requirement, go to the
control panel and press the Stop Key, Multi-Copy Key “0,”
Stop Key, and Multi-Copy Key “1,” in that order, to set the
copier into a state ready to enter a particular Tech. Rep.
Mode.
4. Press the Stop Key and then press the Start Key to set the
copier into the Adjust Mode. (At this time, the Magnification
Ratio Indicator shows “A.”)
5. Press Multi-Copy Key “1 S 2” and press the Start Key.
(Then, the Magnification Ratio Indicator shows “A 12” and
the Multi-Copy Display, the current setting value.)