Specifications

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT
96.11.01
D-59
(10) Adjustment of the Edge Erase Lamp Position
z Requirement
D Edge erase width: Within 1 ± 0.5 mm
z Important
D This adjustment must be made after the reference positions of the Multi Bypass Table and 1st Drawers
have been adjusted.
1. With the Original Cover raised, place a sheet of A4 or
8-1/2” 11 paper lengthwise on the Original Glass.
2. With the Original Cover raised, make a full size copy.
3. Check the erase width on the front edge and turn the edge
erase width adjusting screw as necessary to obtain an
erase width of less than 1 ± 0.5 mm.
NOTE
Loosening the screw will make the erase width smaller.
Tightening the screw will make the erase width greater.