Specifications

Interleaf EP1052 DIS/REASSEMBLY, ADJUSTMENT
96.11.01
D-62
(3) Adjustment of the PC Drum Paper Separator Fingers Position
z Requirement
D The gap between the PC Drum and the PC Drum Paper Separator Fingers should be 1.0 ± 0.5 mm when
the Separator Solenoid is in the deenergized position.
z Important
D Cover the PC Drum with the Drum Cloth to prevent it from being scratched.
D Use care not to deform the Separator Fingers during the adjustment procedure.
D Press part A shown below up against the PC Drum Paper Separator Fingers Positioning Jig for the ad-
justment (to prevent the Paper Separator Fingers from being deformed).
1. Install the Sleeve/Magnet Roller Positioning Jig, to which
the PC Drum Paper Separator Fingers Positioning Jig has
been fitted, onto the Imaging Unit.
2. Turn the set screw on each of the two Finger Holders as
necessary for the adjustment.
3. Ensure that part A contacts the PC Drum Paper Separator
Fingers Positioning Jig when the Separator Solenoid is in
the deenergized position.