Specifications

Interleaf EP1052 GENERAL, MECHANICAL/ELECTRICAL
96.11.01
M-10
1151SBM0500A
PC DRUM5
The photoconductive drum used in this copier is the organic photoconductor (OPC)
type. The drum is made up of two distinct, semiconductive materials on an alumi-
num alloy base. The outer of the two layers is called the Charge Transport Layer
(CTL), while the inner layer is called the Charge Generating Layer (CGL).
The PC Drum has its grounding point inside at its rear end. When the Imaging Unit
is installed in the copier, the shaft on which the PC Drum Drive Coupling Gear is
mounted contacts this grounding point.
Handling Precautions
This photoconductor exhibits greatest light fatigue after being exposed to light over
an extended period of time. It must therefore be protected from light by a clean, soft
cloth whenever the Imaging Unit has been removed from the copier. Further, use
utmost care when handling the PC Drum to prevent it from being contaminated.
PC Drum
Gear
PC Drum Cross-Sectional View
CTL
CGL
Aluminum
Cylinder
Shaft
Grounding
Plate
PC Drum Drive Coupling Gear
Grounding Point