Specifications

Interleaf EP1052 GENERAL, MECHANICAL/ELECTRICAL
96.11.01
M-48
<Control>
Control Signal ON OFF WIRING DIAGRAM
S61 PWB-A PJ9A-1 L H 25-D
S62 PWB-A PJ9A-4 L H 25-E
S63 PWB-A PJ9A-7 L H 25-E
S64 PWB-A PJ9A-10 L H 25-F
S66 PWB-A PJ10A-4 L H 25-G
1158SBM1706A
17-6. Paper Empty Detection
When the Drawer runs out of paper, the Actuator for the Paper Empty Sensor drops
into the cutout in the Paper Lifting Plate. This activates the Paper Empty Sensor and
the copier will know that the Drawer has run out of paper.
As we noted earlier, the Paper Lifting Plate is raised at all times by the Paper Lifting
Springs. To prevent the Actuator for the Paper Empty Sensor (PC101) from being
caught by the paper stack when the Drawer is slid out of the copier, therefore, it is
tilted slightly. This, however, results in the operating stroke of the Actuator
becoming small, which increases the possibility of the Actuator activating the
Sensor by flexing of a sheet of paper as it is taken up and fed in. To prevent this false
detection a paper-empty condition, the paper empty detection is enabled only when
the Paper Take-Up Roll is in the retracted position. (See 16-8. ”Paper Take-Up Roll”
for the retracted position of the Paper Take-Up Roll.)
Paper Empty Sensor
Actuator
<Control>
Control Signal Blocked Unblocked WIRING DIAGRAM
PC101 PWB-A PJ7A-6 L H 25-B