Specifications

Interleaf EP1052 GENERAL, MECHANICAL/ELECTRICAL
96.11.01
M-54
1151SBM1901A
19-1. Upper Synchronizing Roller Positioning
Since the Upper Synchronizing Roller is fitted to the Imaging Unit, it must be
correctly positioned with reference to the Lower Synchronizing Roller when the
Upper Half of the copier is swung down into the locked position. For this purpose,
slits are cut in the lower copier frame and the Bushings of the Upper Synchronizing
Roller fit into these slits.
The Upper Synchronizing Roller is grounded through the Bushings which are in
contact with the frame. To positively ground the Roller, the Ground Plate fitted to the
lower frame makes contact with the Shaft of the Upper Synchronizing Roller.
Upper Synchronizing shaft
Ground Plate
Lower Copier Frame
1151M027YA
1151SBM1902A
19-2. Paper Dust Remover
The Paper Dust Remover is installed so that it makes contact with the Upper
Synchronizing Roller. Since the Upper Synchronizing Roller is covered with a vinyl
tubing, triboelectric charging occurs as the Roller turns in contact with the Paper
Dust Remover. As paper is then fed between the Synchronizing Rollers, the
charges on the tubing attract paper dust from the paper. The dust is then transferred
onto the Paper Dust Remover.
Upper Synchronizing Roller
Paper Dust Remover
Lower Synchronizing Roller