Specifications

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 MECHANICAL/ELECTRICAL
98.04.24
M-47
1174SBM1305A
The length (feeding direction) and width (crosswise direction) of the paper are indepen-
dently detected and the copier determines the paper size by combining the two separate
detections made.
On the bottom of the tray is a lever fitted to the Trailing Edge Stop and another lever fitted to
the Edge Guide. These levers actuate and deactuate Paper Size Detecting Switches to
allow the copier to determine a particular paper size.
The Marketing Area Switch is used to set the type of paper to be used (inch or metric).
The 2nd Drawer accepts only paper of a fixed size and has no paper size detecting system.
(The paper size is input from the control panel using a Tech. Rep. Mode.)
13-5. Universal Tray (1st Drawer) Paper Size Detection
Paper Size Detecting Switches
Paper Length
Inch/Metric Setting Switch S66
Length (FD) Width (CD)
Metric Inch
S61 S62 S63 S64
ON ON ON – 402.0~402.0 A3 11”
×
17”
ON ON OFF
OFF
402.0~349.2 B4
8-1/2”
×
14”
ON 11”
×
14”
ON OFF OFF
OFF
349.4~317.2 FLS
8-1/2”
×
14”
ON 11”
×
14”
OFF OFF OFF – 317.2~272.0 A4L Letter L
OFF OFF ON
OFF
272.0~222.0 B5L
Letter L
ON Letter C
OFF ON ON
OFF
222.0~195.0
A5L Invoice L
ON A4L Letter C
OFF ON OFF
OFF
195.0~195.0 B5C
Letter C
ON Letter L
1151M003AA
Marketing Area
Switch S66
S61
S62
S63
S64
Drawer Set Detecting
Switch S65
NOTE
The number and the installed position of
the Paper Take-Up Rolls vary depending on
the marketing areas: inch or metric. See
pp. M-43 and M-44 for the sizes of the
paper that can be taken up and fed out of
the drawer.