Specifications

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 MECHANICAL/ELECTRICAL
98.04.24
M-51
1174SBM1309A
To minimize the occurrence of paper misfeed due to a slippery Paper Take-Up Roll, the
Paper Take-Up Solenoid is energized a second time if a sheet of paper fails to reach the
Paper Take-Up Sensor within T sec. after the solenoid has been deenergized. The solenoid
is energized this second time 0.5 sec. after the above-mentioned period of T sec. has
elapsed. (This is referred to as the paper take-up retry function.)
A misfeed results if the sheet of paper does not reach the Paper Take-Up Sensor even after
three paper take-up sequences (initial take-up plus two retries).
Here is the control timing chart.
Control Signal Energized Deenergized WIRING DIAGRAM
SL2 PWB-A PJ4A-9 L H 17-F
SL3 PWB-A PJ3A-2 L H 17-D
Control Signal Blocked Unblocked WIRING DIAGRAM
PC55 PWB-A PJ4A-2 H L 17-F
PC56 PWB-A PJ3A-7 H L 17-E
13-9. Paper Take-Up Retry Control
1st Drawer 2nd Drawer
T 1.3 sec. 1.6 sec.
1174T21MCA
1174T15MCA