Instruction Manual

Automatic Infrared Focus Correction Mode
This mode allows for one-step compensation of auto-focus focal range when using infrared film.
(Once the focus correction value is set, all exposures on a roll of film are corrected to the same value.)
Load the infrared film in the camera as
usual, pressing the shutter release button
until “{
}” appears in the frame count
window. Set the Main Switch to “A” and
press the SELECT button hold for while until
the ISO speed is shown in the display. Then
press the DOWN button until the “ISO･･･”
reading appears.
Then press the MF button once to displa
y
“750” or once again to display “850”. These
are the wave-length values for infrared films.
Choose the correct value for the film in use
(refer to table below). After 3 seconds, the
display will show “ISO 100” and the selected
infrared focus correction value will remain in
effect till the end of the roll.