Instruction manual

2322
ATTACHING THE RING FLASH
2. While pressing the tabs on
both sides of the ring flash,
place the ring flash over the
adapter, then release both
tabs.
• Attach the ring flash directly to the AF
Macro Zoom 3X-1X f/1.7-2.8 lens.
3. Remove the protective socket
cap.
• For safe-keeping, place cap in bag.
Replace cap after use.
1. Screw the appropriate adapter
ring onto the lens.
• 49mm and 55mm diameter adapters
are provided.
• If using the AF 200mm f/4 Macro Apo
G lens, a 72mm adapter is needed,
which can be be purchased sepa-
rately (p. 64).
Strong shadows can be softened by
using the diffuser attached to the
flashtube. Always use the diffuser with
an arm (p. 48).
The angle of flash coverage
will increase if you attach the
wide-angle adapter to the
flashtube (p. 46).
• Do not allow the cord to get in front of the flashtube or lens.
• Make sure the flashtube is pointing at the subject.
• See page 56 for photographic examples.
• If an arm is used when taking very close-ups with the AF Macro 50mm
f/2.8 lens, the subject may not receive sufficient lighting (p. 57).
• The AF Macro Zoom 3X-1X f1.7-2.8 lens can not be used with the
twin flash.
ATTACHING THE TWIN FLASH
Continued on next page