User`s guide

Dual In-Line Memory Modules 111
You may also need additional memory (DIMMs) for the following:
„
To print complex graphics or complex PostScript documents
„
For increased collation performance
„
For increased spooling performance
The magicolor 2200 has 3 DIMM slots available. The maximum memory that can be
installed is 384 MB (3 x 128 MB DIMMs).
„
Check the startup page to make sure the printer has enough RAM installed.
„
If you have enough RAM installed, and you have configured the printer from the con-
trol panel to print at 600x600 or 1200x1200 dpi resolution (Administration/Engine/
Def Resolution menu) but the printer continues printing at a lower resolution, you may
need additional memory allocated to the frame buffer. (See the
CrownBook
for
instructions.)
To allocate the default amount of memory to the memory clients, use the Memory/
Quick Config menu to choose the correct resolution and paper size for your printing.
If you experience a problem with your magicolor 2200, first go through the installation
procedure in this guide once more. Verify each item thoroughly. You may also refer to
the
User’s Guide
for troubleshooting tips. If you still experience a problem, contact your
local vendor or contact Customer Service at 1 [phone] (toll-free US).
Model Standard Memory Supports up to...
N
64 MB SDRAM DIMM
4-color 600x600 dpi simplex printing, at speed, on all paper
sizes up to and including 8.5" x 14" (215 mm x 356 mm)
GN, EN
128 MB SDRAM DIMM
1200x1200 dpi simplex printing on paper sizes up to and
including 8.5" x 14" (215 mm x 356 mm)
DP
256 MB SDRAM DIMM
(2 x 128 MB SDRAM)
Full-speed duplexing at 1200x1200 dpi printing with most
paper sizes