Minolta Magicolor 2200 : User`s guide : Page 113

Dual In-Line Memory Modules 113

5

If you need to remove a DIMM before

installing one, remove it as follows;

otherwise skip to step 6.

5"

If all the DIMM connectors are filled

and you want to install more memory,

you have to exchange one or more

DIMMs for DIMMs with a greater

memory capacity.

a

Using both thumbs, pull the latches

(one on each side of the DIMM con-

nector) outward.

b

Lift the DIMM straight out of the

DIMM connector.

6

Insert the new DIMM straight down into the DIMM connector until the latches snap

into the locked position.

Observe the keyed side of the

DIMM to align it with the connec-

tor. When seated, the DIMM stands

upright, firmly in place. If you can-

not snap the DIMM into place, do

not force it. Reposition it, making

sure that the bottom of the DIMM is

seated completely in the connector.

7

Repeat steps 5–6 for each additional

DIMM that you install.

8

Reinstall the controller board into

the printer.

Gently slide the controller board

into the printer until it is fully seated, and then tighten the five screws.

When you print a startup page, verify that the total size of the RAM installed in your

printer is listed.

IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII

................................................ ........................ ..........

IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII

................................................ ........................ ..........

IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII

................................................ ........................ ..........

IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII

................................................ ........................ ..........