User`s guide

Interfaces and Daughterboards122
What’s in the Kit?
An optional interface kit includes the following:
„
An interface card
„
Interface documentation (in hardcopy and/or on CD-ROM)
The kit may also include additional parts not required for network interface installation on
this printer.
Installation
Attention
It’s very important to protect the printer controller board and any associated circuit
boards from electrostatic damage. Before performing this procedure, review the
antistatic caution on page 112. In addition, always handle circuit boards by the edges
only.
1
Turn off the printer, and then disconnect the power
cord and all interface cables from the printer.
2
Loosen five screws and, using the tab on the lower side
of the panel, pull the controller board from the printer.
3
Remove the two screws holding the metal plate over
the optional interface opening.
The optional interface opening is labelled “Option.”
It’s located next to the “Parallel” port. Save the two
screws. (You’ll use them when you install the optional
interface card.) You can dispose of the plate according
to local regulations.