User manual

PaperCut –Konica-Minolta Embedded Manual 2015-02-17
Copyright © 2015 PaperCut Software International Pty. Ltd., All Rights Reserved. 29 of 44
ext-device.konica-
minolta.login.confirm
ation.enabled
Setting this to “N” allows you to bypass the confirmation
screen shown after a successful login.
Note that this was replaced in by the standard configuration
checkbox “Show account confirmation” on the device
summary tab. The old setting will be automatically migrated
across.
ext-device.card-no-
regex
See chapter 6.3 “Configuring Swipe Card Readers”
ext-device.konica-
minolta.restricted.all
ow-multiple-login
Setting this to “Y” will allow users to log in and charge copy
jobs to a restricted account (user account or shared account)
if another copy job charged to the same account is still in
progress. This may cause cost overruns with users going into
negative balance.
ext-device.konica-
minolta.card-
decoder-hid
Selects the method used to read a user ID from an HID RFID
card reader. 0 → the card number field from OmniKey
readers is used as the PaperCut user ID. 1→ the entire data
on the reader is used as the PaperCut user ID.
ext-device.konica-
minolta.card-
decoder-force-mode
Overrides card reader auto detection and forces a decode
mode, useful where reader detection and consequently
decoding of card numbers is unreliable.
Currently supports the following values:
DEFAULT - Automatic mode
AU201 – Force decoding of numbers compatible with AU201
card reader
RAW_HEX – Skip decoding and output hexadecimal encoded
values sent from the card reader as is, useful for interfacing
with custom JavaScript converters.
ext-device.konica-
minolta.email.perso
nalized-sender
(OpenAPI 3.1+ only) If set to “Y” will pre-populate the email
address in the device’s Scan-to-Me function as stored in the
user’s details in PaperCut
ext-device.konica-
minolta.display-
balance
(OpenAPI 3.1+ only) If set to “Y” will display the balance on
the device’s screen while using copier functions. Display will
not be accurate for users with overdrafts. Unrestricted users
will display as “99999999”. Set to “DEFAULT” or “N” to not
display balance.