User manual

PaperCut Konica-Minolta Embedded Manual 2015-02-17
Copyright © 2015 PaperCut Software International Pty. Ltd., All Rights Reserved. 8 of 44
3.8 Requirements
Before installing the PaperCut Embedded Application into the Konica Minolta device,
ensure that basic monitoring of network printing has been setup up and tested for this
device. The device would show up in the printer list in the PaperCut web interface
and have a few print jobs in its print history.
After that, ensure that the following points are checked off before getting started:
PaperCut is installed and running on your network. Please see the
‘Introduction -> Quick Start Guide’ section of the PaperCut user manual for
assistance.
Ensure that your Konica-Minolta device supports OpenAPI 2.3.1 or later with
OpenAPI 3.1 or later is recommended.
Ensure that the Konica Minolta device is connected to the network.
Have available the network name or IP address of Konica-Minolta device.
It is recommended that the device be configured with a static IP address.
Verify that firewalls or other network restrictions don't prevent the PaperCut
server’s access to port 50003 on the device and don’t prevent the device’s
access to the PaperCut server on ports 9191 and 9192.
3.9 Setup Procedure
3.9.1 Configure OpenAPI Settings
Log on as administrator onto the device’s web interface (called “Page Scope
Web Connection”) under http:// <ip-address-of-device>/ . Tip: The default
administrator’s password usually is “12345678”, on some newer devices it is
“1234567812345678”.
In the “Security” section display the “PKI Settings” subsection. If there is no
“PKI Settings” subsection, please ignore this section and refer to Appendix A
instead for configuration of older devices.
Create a new certificate following these steps. (Even if a certificate is already
shown in the “Device Certificate List”, this certificate may not be usable for
SSL. Please delete it and re-create a new one.)
o Click “New Registration”, select “Create and register a self-signed
Certificate” and click “OK”.
o Fill in the fields with some values about your organization. The values
have no functional significance.
o For the Validity Period the maximum number of days offered is
recommended (usually 3650 = 10 years).
o “Encryption Strength” can be left to the default values.
o Click OK. The certificate will be generated. You will be asked to switch
the device off and on again.
Log onto the device web interface as administrator again and in the “Security”
section display the “PKI Settings” subsection and from the menu on the left
choose “SSL Setting”. Change “Mode using SSL/TLS” to “Admin Mode” or
“Admin Mode and User Mode” (on some machines: just “enable”). Your web