User`s guide

6
Working with the printer
6-6
4
Squeeze the right media guide and adjust the media guides so that
both the left and right sides of the media are secure.
Loading media in the manual feed tray
1
Open the media guides.
2
Insert the piece of media as far as
possible into the manual feed tray
(with the side to be printed facing
up).
?
How many pieces of media can
be fed at one time?
➜ Insert only one sheet of paper or
type of media at a time.
?
How are envelopes fed in?
➜ Place the envelope in the tray with the side to be printed facing up.
The flap of the envelope should be facing down and to the left.
?
How is letterhead fed in?
➜ Load letterhead with the side to be printed facing up and the pre-
printed letterhead at the top (facing the printer).
Loading media in the lower feeder unit (Tray 2)
Note the following points:
✔ The optional lower feeder unit (Tray 2) is shipped with either a letter or
A4 tray. Legal and executive/B5 JIS trays are also available as option-
al accessories.
✔ Refill the tray only when it is completely empty.
✔ Paper must be loaded short edge first.
✔ Refer to the advice on loading media on page 6-1.
1
Remove Tray 2 from the lower feed
unit by pulling it out as far as it will
go, gently raising up the front, and
sliding it the rest of the way out.
Downloaded From ManualsPrinter.com Manuals