Printer User Manual

3-15
Chapter 3Using Your Printer
TIMING
Sets the timing of “Busy to Ack” in the communication format
between the printer and PC. Basically, you don’t need to change
the setting. However, depending on the PC you are using, it may
not be able to support a proper communication between the
printer and PC. In such a case, change the setting after verifying
the PC specification.
A-B: Ack in Busy.
A-B-A: Ack while Busy.
B-A: Ack after Busy.
ADOBE PROTOCOL
This item appears only when PostScript is installed.
Standard: Tells the driver to send data to the printer in a ASCII
format.
Binary: Tells the driver to send data to the printer in a binary for-
mat.
TBCP: This allows you to change between ASCII and binary for-
mat by a particular control code.
TIME OUT
The Time Out setting determines the time out period from the end
of the print job to the ready state. After the time out period, the
printer searches for next data from interface channel.
2. Understanding the Printer Menus
OperatW3.frm 15 ページ ２００３年１１月１８日 火曜日 午前９時５１分